**please note: there are two versions of this case

• Version 1 includes the adhesive on the case
• Version 2 includes the adhesive on the back of the insert. Remove protective film from magnet before attaching insert 
  • version 2 will not be restocked

 ----------------------------------------------------------

• phone case material: PC+TPU
• magnet built directly into the case for wireless charging
• MagSafe-compatible sublimation insert included
• insert has matte finish
• permanent adhesive included
• individually wrapped

Suggested Heat Press Setting:

• 385°F
• 30-45 seconds
• too much heat or pressing too long can cause shrinkage of the insert
• remove protective film before pressing
• adjust settings as needed based on your equipment